Saal WallArt
Order Management Tool
Prices
Photo Book
Wall Art
Prints
Posters / FineArt
Cards
Photo gifts
Photo calendar
Gift certificates
Order Now

Stand-off

Particularly suitable as a mount for signs, or similar, especially outdoors. With this option, your Wall Art will be delivered with the stand-offs and pre-made holes.

Available for: Metal Print, Brushed Metal Print, Acrylic, GalleryPrint, PVC foam board

Stand-offs Wall Mounting

Features

  • The stand-offs are not pre-mounted
  • The heads of the stand-offs are visible from the front
  • Good for outdoor use
  • Available for select sizes

Available to order separately: Yes, you can order them separately, but remember that your Wall Art needs to already have the holes made in production.

Distances of the suspension

The stand-offs will create a separation of 2 cm from the wall. When it comes to the distance between the screw holders and the edge, it will depend on the format:

  • For smaller formats: 1 cm
  • For bigger formats (starting from 20 x 30): 1.5 cm
  • For custom formats: always 1.5 cm

Assembly instructions

Materials required:

  • Wall art with pre-drilled holes
  • Screw mount
  • Screws
  • Screwdriver or drill (depending on wall material)
  1. Select the desired location for mounting the wall art on the wall. Mark the positions on the wall accordingly. Use a spirit level to make sure the marks on the wall are straight and aligned.
  2. If you do not already have holes in the wall, drill four holes at the marked locations. The size of the holes should correspond to the screws that came with the screw bracket.
  3. Make sure the holes are deep enough to fully accept the screws.
  4. Take the screw bracket and place it in front of the wall art. Position it so that the holes in the screw bracket line up with the pilot holes on the back of the wall art.
  5. Insert the screws through the holes in the screw holder and screw them into the prepared holes in the wall. Use a screwdriver or a drill, whichever is appropriate for your wall material.
  6. Tighten the screws but be careful not to overtighten them so as not to damage the wall art. Finally, tighten the heads of the screw holders by hand.
  7. Check that the wall art is securely and firmly attached to the wall. The screw heads are visible from the front and give the wall art an impressive attachment.

Congratulations your Wall Art is now hanging on the wall.

Stand-offs assembly